Get Adobe Flash player

ROMESS-Rogg Apparate + Electronic GmbH + Co. KG
Dickenhardtstraße 67
78054 Villingen-Schwenningen

Tel. +49 (0)7720-9770-0
Fax +49 (0)7720-9770-25
E-Mail info[at]romess.de 

When customers complain about vibrations while driving and/or irregularities in acceleration, the cause can be a deviation in the buckling-angle of the drive shaft from the set point. So far, there were only mechanical tools available to gauge the drive shaft.

With the new electronic drive shaft angle gauge Romess 09935, the process is significantly easier and more accurate at the same time.



 

 

 

 

 

 

 

 

 

 

 

 

 

 

Structure and function
The angle gauge 09935 consists of a hand held unit with graphics display and a sensor for measuring two levels. The measuring range is +/- 15°.

To evaluate the alignment of the drivetrain, you must first measure the angles of the transmission, the prop-shafts and the rear axle differential.

Different adaptations are needed for the sensor gauging the transmission and the differential. To measure the prop shafts, the measuring cones on the sensor can be held directly on the prop shaft. The result are shown on the display and saved by pressing the "Save" key. From two angles the unit calculates the difference which is relevant to the correct alignment of the drive shaft (difference ∠1∠2 = φ1; difference ∠2 ∠3 = φ2; difference
∠3 ∠4 = φ3).

The sensor distinguishes between the x- and y-axis. To receive accurate results, the spiral cord on the sensor should always point toward the front of the vehicle.

Characteristics
- high measuring accuracy
- easiest handling
- power supplied by customary rechargeable batteries (4 x Mignon
  AA 1.2V/2100 mAh)
- battery charger

Technical data
- CE certificate, Protection IP65
- Power supply: 4.8V – 6V, 0.8W
- Angle measuring range: +/- 15°, accuracy +/- 0.1°
- Equipment: USB-interface and serial R232 for data transfer
- Battery charger (12V/250mA)
- Measurements (in mm): L x W x H: 450 x 380 x 120 (in the case)
  approx. 205 x 100 x 70 (without case)
- Packing measurements (in mm): L x W x H: 455 x 400 x 120

Scope of delivery
Operating device with display, inclinometer, power supply, standard adapter (09606-50), carrying case.

Accessories
- data transfer and charging station with power supply, data cord (9 pole,
  1.2 m length) (09630-10)
- interaxle-adapter (Type W163 M-class), MV-level measuring front axle
  (09606-60)
- interaxle-adapter (Type W163 M-class), wheel caster measurement rear axle
  (09606-61)
- adapter for W 414 (Vaneo) station wagon and panel truck (09606-62)

Order Numbers
09606-10 (230V/50Hz)
09606-11 (110V/60Hz)

Modifications and errors reserved.

Um unsere Webseite für Sie optimal zu gestalten und fortlaufend verbessern zu können, verwenden wir Cookies. Weitere Informationen zu Cookies erhalten Sie in unserer Datenschutzerklärung.